AccuTouch® 3000U USB Controller (Discontinued December 2006)
规格
-
技术
产品料号
608244-000
技术
accutouch
接触数
单点触控
输入法
手指
手套的手
被动触控笔尺寸
2.28" x 3.50" x 0.65" / 57.9 mm x 88.9 mm x 16.5 mm
接口
USB High Speed
Plug and play compatible表面处理
透明
分辨率
Approximately 4096x4096, 12 bit resolution
Conversion Time
Approximately 8.6 ms per coordinate set
电源
+5 VDC, nominal (+4.35 to +5.25 VDC)
50 mA, typical at +5 VDC. Average power dissipation is 0.25 W, typical
Power is obtained from 5V supply on the USB connector. No external power supply is needed.
Total noise and ripple requirement must be less th输入电压
+5 VDC, nominal (+4.35 to +5.25 VDC)
电源输入
Power is obtained from 5V supply on the USB connector
Reliability
MTBF greater than 250,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for the ground benign environment with an ambient temperature of 25°C
Construction
Four-layer surface-mount design with internal ground plane for EMI suppression
Flammability
The printed circuit board substrate is rated 94V0.
All plastic components, such as headers and connectors, are also rated 94V0.
In addition, circuitry is protected by Raychem Polyswitches, which are UL recognized components.Shock and Vibration
ISTA 2A standard for shock
Three axis sine wave, 50Hz to 2kHz, 1G, 2 minutes/Octave with dwell on resonanceESD
Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV for USB and screen connector
工作温度
0°C to 65°C
操作环境
AccuTouch SmartSet protocol
Initial/Stream/ Untouch/ Z-axis Enable Modes储存温度
-25°C to 85°C
湿度
Operating: 10% to 90% RH, noncondensing
Storage: 10% to 90% RH, noncondensing高度
10,000 ft maximum
MTBF
50,000小时演示
安装选项
All mounting holes are plated through-holes for chassis ground connection.
Connectors and Pin Definitions
The connector configuration permits the controller to be placed in-line between the touchscreen and a USB hub or host attachment.
控制器电缆
Contact Elo for more information.